UA-71238615-1 Jump to content
  • V1.1 Multistruder Plans


    Steven Mosbrucker

    BOM:

    Steel:

    • 3/4" Square Tube 1/16" Wall 2" long (two required)
    • 3/4" Square Tube 1/16" Wall 4" long (one required)
    • 5/8" Square Tube 1/16" Wall 12" long (two required (second one required for version 1.1))
    • 2" x 4.5" x 1/4" Plate (one required)
    • 4" x 12" x 1/8" Plate (one required)
    • 4" x 4" x 1/8" Plate (one required)
    • 4" x 4" x 1/4" Plate (one required)
    • 3.5" x .5" x 3/16" Bar (three required)

    Drill Bits:

    • 1/2" 
    • 5/32"
    • 7/32" or 5.50mm
    • 21/64"
    • 2.50mm
    • 1/4"
    • 1"

    Process:

    1. Cut Steel:
      • Cut the steel to size listed in the BOM for steel.
    2. Drill Holes:
      • Drill the 4" x 12" x 1/8" plate using the 5/32", 21/64", and the 1/4" bits the pattern bellow
      • 1st: drill all the holes with the 5/32" bitIMG_20160715_170653375.jpg
      • 2nd: drill all extruder side holes with the 1/4" bitIMG_20160715_181534790.jpg
      • 3rd: drill the 2 extruder mounting holes with the 21/64" bit. Pictures bellow of that processIMG_20160715_191242224.jpg
    3. Drill Holes in the 2" x 4.5" x 1/4" motor mounting pateIMG_20160720_173646123.jpg
      1. Drill all holes with the 7/32" drill bit in the pattern you see bellow. IMG_20160720_173930211.jpg
      2. Step up the 3 middle holes with the 1/2" bit as seen bellow. IMG_20160720_181250943.jpg
      3. Step up center hole to 1" drill bit (optional you can use a 3/4" bit as a intermediary bit). IMG_20160725_141947715.jpg

    IMG_20160722_181130286.jpg

    IMG_20160722_181314363.jpg

     

    IMG_20160725_141954219.jpg

    IMG_20160725_142728921.jpg

    IMG_20160725_142321203.jpg

     

     

     

    IMG_20160801_163450123.jpg

    IMG_20160801_174813176.jpg

    IMG_20160801_175016367.jpg

    IMG_20160801_175209727.jpg

    IMG_20160801_181339577.jpg

    IMG_20160801_181359116.jpg

    IMG_20160801_181714196.jpg

    IMG_20160801_185806440.jpg

    Edited by Steven Mosbrucker



    User Feedback

    Recommended Comments

    There are no comments to display.


×