Jump to content

Leaderboard


Popular Content

Showing most liked content since 07/16/2017 in all areas

  1. 1 point
    went to cut some more wens day and the cam software running the cutter is ignoring the inner squares on the spacers so need to figure out why it is doing that. but going to be cutting again this weekend.
  2. 1 point
    Got some cutting in this week Got the calibration of the fusion 360 done to get the center square perfect going to finish up an entire shredder this coming weekend i am still shopping for bearing setup and a drive shaft supplier full product coming very soon Check bellow for a lot of pictures.
×
UA-71238615-1